oil level AUDI A4 1999 B5 / 1.G 01A Transmission Rear Final Drive Remove Install Workshop Manual

39-108


Notes: - Use transmission hoist, to raise final drive far enough until both drive
axles can be installed.
- Tighten drive axle bolts slightly.
- Raise final drive and bolt to crossmember and transmission support.
- Install drive shaft Page 39
-74
.
Always replace self-locking bolts for driveshaft.

To prevent imbalance, the flanges of the driveshaft (arrow -A-) and of
the final drive (arrow -B-) must be installed so that the factory color
markings (or the color markings made during removal) are aligned. After removing driveshaft from final drive, additional balance disc
(thicker washer) which may have been installed between base plate
and bolt head may not be re-installed.
- Check oil level in final drive Page 39
-84
.
Pa
ge 5 of 7 Rear final drive, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.12